Remote For Gas Logs Not Working

Remote For Gas Logs Not Working – When you find that your remote isn't working, it's a good idea to check your receiver as well to make sure the batteries are working in there too. After you've changed the dip switches and they match up, the remote control should once again operate the fireplace. The logs flame on manually but the remote will not light them with the on or on the thermo mode. If it does not, either your receiver box is broken, or more likely you'll need to contact a gas plumber as your fireplace is not in working condition.

Valve will not turn “off” with remote? While most remote controls leave the pilot light on and idle, electronic ignitions turn the pilot light on and off the same way it switches off the flames for your. How to reset your remote & receiver. Please watch video on syncing remote control first.

Remote For Gas Logs Not Working

I have changed both sets of batteries and tried to relearn the. If your gas logs do not light, check the batteries in the remote and in the receiver which is located within the log set. Make sure heat shield is installed.

Motown fire 103 subscribers subscribe subscribed 62k views 3 years ago. The gas valve controls the flow of gas to the burner and is typically controlled by a wall switch or remote control. My family hasn’t used their gas fireplace all summer, so there’s a good chance some of the components are.

If these steps seem too complicated, this is an easy fix for a fireplace. Purging the air from the tubing allows gas to flow through it and produce a flame more easily. Check batteries and relearn remote kit.

First, check to see if the batteries in the remote control are. If you gas logs won’t light it could be an issue with your remote. If there is a problem with your remote’s signal transmitting, the first and easiest thing.

Remote Control Manual For Gas Logs Fine's Gas